Search results for query: *

Trick flow makes an intake for them but really any intake would be fine for them like edelbrock air gap intake or a nice single plane intake

Im selling my pair of SB Mopar trick flow heads part # TFS-61417802-C00 they're new never been bolted on asking $1,900 + shipping I'm located in Virginia

Would not getting good consistent spark make it feel like it was braking

I don't think it was even the transmission I don't think we was getting good spark we changed spark plug wires and distributor and now it's running right

No only changed transmission fluid and filter

It has a pinion seal leak we just got a new seal to go back in it we haven't changed it yet

He just got the car it had a 340 in it and I had just rebuilt a new 340 and he just swapped that engine out for mine the transmission ran good with the old 340 and it ran good with my new 340 then we changed the transmission fluid and noticed that the differential was really low on oil it has a...

And it don't shift gears unless we do it

Yeah drive is first gear

It had a different 340 in the car when we got it and we drove it about 60 miles and it was good never done anything like this

And I'm not 100% sure it's the transmission we drove the car a few miles got back home checked the differential fluid and it was really low it needs a new pinion seal we just got one to put in it

It's really my brother's car and my brother changed the fluid I don't think it has a shift cable but there is linkages

I read Chrysler recommends atf+4 for all torqueflite transmissions now

I did change the filter

I have a 727 transmission in a 75 scamp with a built 340 it has a reverse full Manual valve body it was running good then I changed transmission fluid and put atf+4 in it now when driving sometimes it feels like the car is braking and holding it back I can floor it in 2nd gear and it want tach...

On imm engines facebook he built a 506hp 506tq 408 with tf heads

Imm engines facebook page I asked him if he dynoed one yet

Imm engines said This first engine is a very mild small hydraulic flat tappet 408 build, but we made 462 horsepower and 486 torque with them.

IMM Engines facebook page says the heads flow 290cfm @ .500 lift I would think that cam should make more than 439hp with those heads

We ran a 408 on the dyno today with a set of the Trick Flow heads. Engine had a Performer RPM intake, Holley Sniper setup and a 230/236 hyd roller cam. It made 450 hp and 490 torque. Not bad numbers for sweet street engine. It idled super smooth with a ton of vacuum and was a very quiet and...

Which head on summit has the hydraulic roller springs?

My lil 340 when in car ill post another pic.

If anyone was wondering I read an article about the x heads they used if I remember right they flowed 215 cfm