Search results for query: *

My 1969 340 is 40 over, when I pulled the motor to freshen up the cylinders still had a fresh hone so I just did the heads over new gaskets painted and back in, but I did go with a new comp cam xe268h lifters rods and rockers. I just lined up the dots no dial in. Without taking the engine to far...

Where can I find the correct header seal that is glued into the leading edge of the channel. Not the seal that goes over the screws and runs into the rails. What I have left is badly disintegrated so not sure of the correct design. Ty

Looking for a decent driver antenna, need everything from radio to mast ty

Looking for a power steering shaft and coupling for a 1967 barracuda

Trying to get parts together to convert to power steering for a 1967 barracuda will a 3643012 gear box from a 1972 valiant work. Can get pump hoses and box with pitman arm in one purchase if it will work. I know the pump bracket won’t work will have to work on that, I already have a steering...

Looking for sb power steering pump with bracket for a cast water pump driver side outlet and gear box. hoses and the pitman arm would be a plus. 67 cuda with a 360. I have the column shaft and crank pulley ty

Installed new gauges and circuit boards, pull harness and cleaned, repaired and inspected. Reinstalled with new tested ok gauges now fuel and oil peg( they move up slowly not instantly), temp nothing but shut off after a minute didn’t want to fry another set of gauges. No directional or flasher...

My 1967 fish flasher switch is wired differently, supposed to be 2 green 2 tan 1 red and 1 white. I only have 1 tan, the tan leg from the dash cluster (right turn signal)is going to the bulkhead v location so I have 2 wires there. It looks like ma mopars work and everything rings out at all...