Search results for query: *

1966 plymouth valiant rear axles does anyone know the length and spine count, 7.25

1966 plymouth Valiant I'm sending off my rear axle to be redrilled from 4" to 4.5. question I have is what year drums will fit them at 4.5? local auto zone could not tell me without a year and model... 9"

anyone know of upholstery mfg in bama or miss? had them saved but computer died and lost address they had mopar replacement covers.

bought these and they don't fit a convertible there for a 69 Barracuda $125 plus the ride

1966 plymouth valiant need rear seat any color ,have new on order but 8 months out they tell me.

Was going to order my upholstery for the rear seat and they also had these listed for my seat. Not sure what there for ?

Hunted around and ca't seem to find a windshield for a 66 vert, seems gaskets and windshield are no goes, unless you use something else?? but what?

Does anyone sell convertible top frame parts, I call it a hinge midway on the frame and mine is broken?

1968 Barracuda 318 auto: Car will start in any gear, new safety switch , new starter and relay, wires under hood look ok hard to tell under the dash. checked plug it's new also . had this trouble since I bought it

1966 valiant power steering column , can you replace the bell setup on the end of column with a Universal Steering Single U-Joint ?

powers up and moves fluid. Asking $150

Working on my 66 with the 1971 318 in it, First I found 2 been push rods and then 2 stuck valves, got the fixed ,now it turns over slow and my cables heat up. Firing order is right, #1 top dead center crank on the mark , rotor on number one. got weak spark going to plugs .... fully...

I have 2 stuck valves on a 71 318 engine , any suggestion on free-ing them.

looking for a exhaust manifold for 1966 valiant 273 driver side.

My 30 min job turned into a nightmare, went to put on my new valve covers today, Did drives side now problem went to passengers 4 bolts came right our then 5th seems like it was broken off by someone and they used a ton of silicone on it. To make it worst after close inspection there may be a...

new in box Antenna for 68-68 Barracuda $90. shipped SOLD

1968 Barracuda 318 auto, He's the problem. start up and runs fine after a couple minutes no fuel wait a couple mins and it starts and does same thing. new fuel installed 2 nd one new carb new gas tank new sending unit... Car did the same thing for old owner before replacing stuff . Any ideas?????

I'm about to install my weather stripping on the top/glass meet , here's my question Got some pieces that are soft and 2 pieces that are a harder rubber ? And do I cut them at angles to fit? Got them from soffseal

Got my 68 almost ready now , just put new hoses and power steering pump on it Here's my question What V-belt goes where, as I don't think they were right to begin with.. 318 power steering alt no a/c

I have a set of 4 rally3 wheels and tires and a local person wants them, when I get my new Craigar SS ones whats a fair price tires have no miles on them. 14" large 4.5 bolt pattern

need heater control for 68-69 barracuda part that goes in dash

Shift from a 68 barracuda , missing top knob $75 and shipping

pARTS FOR A 68-69? BARRACUDA antenna $20 and shipping SOLD

Will a A/C heat control work on a non A/C car as far as heater/defroster control? 1968 Barracuda 318 auto

I restored this panel best I can, and have the Detroit muscle decal ready to glue on (I can or you glue them on) asking $300 plus shipping, if for a a/c car and I need non a/c can take trade for it non a/c dash

68 -1970 fender emblem new $55.00 free shipping also used one for less

Starting to work on hooking up A/C in my Barracuda, So here's my question " will a Sanden compressor bolt up to this bracket anyone else have this setup

seat belt bolts need 4 for front seats 68 barracuda

Looking for 3-4 clip to hold rear trunk molding on 68 Barracuda

Just got my Barracuda back from body shop and won't start, relay clicks when you turn key, is the a way to check starter with out pulling it?