Search results for query: *

Please send me pictures of you car that has the rear narrowed to 48 in. Thank You

It is the buttom one. I'll try resetting it and blocking it from working when I'm bleeding the brakes. Thanks for the help.

the front brakes, i have a bkl250

I have a problem with my brakes, I had to change my distribution block when I added rear disc brakes. When I went to bleed my brakes the brake peddle pumped one time and then became locked up and would not release. I went to 4 wheel disc brakes. I'm wondering if it may have to do with the...

A while back I posted a thread on a 8.75 rear housing I had bought and was wondering if it was to narrow to us on my 72 dart. It was narrowed to 48 inches. A member had sent a reply telling me that he or she had a dart that had a 48 inches rear along with some pics of the car. I did not save the...

How much are you asking?

Just the regulators I think have not taken them apart yet. The man I got the dart from had taken them out to lighten the car and put in plexglass window for racing.

I'm looking for both window regulators for my 1972 dart swinger.

It looks like it is bent on passenger side next to the center section about 1/2 inch.

I am ordering axles from DiffDoc after get the housing narrowed and measured to see what tires and rims I can fit with the springs relocated,

The other housing I had was bent to bad to work.

I Have a 8.75 axle housing out of a 73 charger can it be narrowed enough to fit a 72 dart with relocated springs.

Thank you. I'm going to mini tub and try to run 15x10s.

Will the housing I have work or has it been narrowed to much{it was already narrowed when I got}? Is there anyway to make it work for this setup or will I have to get another housing?

It is a 72 dart and that is the same set up I was looking at. The 53" is that measured from the axle flange to axle flange?

The spring location kit is to move the springs under the frame rail. It is 48 1/2 from housing flange to housing flange.

I have a narrowed 8.75 rear end that is 48 1/2 inches from flange to flange. Will this work with a spring relocation kit?

Thank you that should help me measure for the wright size tire that I can fit in the wheel well.

I have the axles that came out of the rear end but they are not usable be cause of condition. I'm going to get after market axles more than likely Moser. The axles i have came with the rear end that was already narrowed

Thank you the rear end is a 8.75 with 489 case and 4.10 with truetrac, it is already narrowed to 48 inches flange to flange. Will have disc brakes. Trying to figure what size tire will fit under it with a mini tub.

I am relocating my springs to the inside with mopar relocation kit. What width should the rear end be

I'm looking for a 8.75 rear axle housing for a A body. Just the house no center needed unless it already has one. please pm me or call 210-902-1442