Search results for query: *

Looking to see if there is another source for the mopar right angle adapter gaskets. Looks like they are sold out everywhere. Does felpro make one?

Update, with the third member installed i have 25 1/2 from the center of the carrier to the end of the housing. The right axle is 25 1/4 from the bearing retainer to the end of the shaft and the left is 25 5/8 . This means they are not touching the center pin in the carrier. I am not sure how...

Update from a previous thread. I received a replacement 408 from blueprint to replace the one that failed . Everything was going great, no leaks, good power. i was really taking it very very easy with this motor, not going above 3,000 rpm no hard accelerations etc. Now have almost 600 miles on...

Salinas warehouse fire destroys several classic cars over the weekend I see a coronet, back end of a barracuda and possibly a charger

Photos from the Fire. Notice the cars. Good news is looks like some survived the inferno.

Anyone have a problem with the 8 3/4 pinon nut loosening up. I just re torqued it to 20 Ft PDS, Ill see if i holds . Never had this happen before. 2nd time its come loose after an engine swap since July.

I ordered a set of these headers from summit and they did not come with the 1 5/8 gaskets for for the driver side header. Does anyone have a part number that I could get locally. Already called Summit and hopefully will have the gasket this weekend. However I would like to know a source for...

Looking for the washer and the clip that holds the throttle cable to the throttle cable bracket on the inside of the passenger compartment. The bracket is for v8 cars specifically 64- 66 dart, barracuda, valiant.

I see on this forum lots of folks who have swapped over to a 360 with the 10.5 inch clutch and have installed Dougs headers. I just mocked mine up and I see there is going to be some clearance issues with the z bar and clutch fork that I have been using for 20 plus years. I called brewers...