Search results for query: *

  • Users: kenelder
  • Content: Threads
  • Order by date
  1. kenelder

    [WANTED] 67-70 steering wheel for Dart

    Looking for reasonable priced blue steering wheel like in the photo. Please PM me if you have one. Thanks, Ken
  2. kenelder

    3D printed fuel sender gaskets

    Replacing the sender in the tank of an A body typically results in a leak around the replacement rubber gasket. There’s been comments about the new lock rings being too thin, etc. Having a 3D printer handy and knowing TPU filament is flexible and impervious to gasoline, I’ve been using it for...
  3. kenelder

    Damaged Pressure Plate Straps

    Hello all, I am hoping some of you might have had this problem before and can shed some light on it. The pictures are a brand new Pressure plate from my 1970 Dart 340. I've had a heck of a vibration with the new engine and clutch parts and finally tracked it down to the pressure plate drive...
  4. kenelder

    340 8 bolt crank info wanted

    I am trying to get more info on the 340 crank pictured below. It has an 8 bolt hub and the snout shows 37686 stamped on it. I’ve been told it is a Mopar Performance stroker crank but I cannot find any info on the stamped number. If any of you could help with info on this crank I’d sure...
  5. kenelder

    [SOLD] Factory Dual Point Distributor

    This is a Mopar factory dual point distributor refurbed, tested and curved by HalifaxHops and was used to start the engine one time. Turns out my Dart had wiring problems and while fixing that I switched to electronic ignition. Has new points, condenser, bushings, cap and rotor and was...
  6. kenelder

    Hole in #1 cylinder wall near bottom

    I thought everyone might like to see what happens when a timing cover bolt brakes through the cylinder wall. Here’s some pics. What happened? Installing new power steering bracket and felt the bottom bolt get right before it was seated on the bracket. Didn’t torque it, so backed out and used...
  7. kenelder

    Bronze distributor shaft gear wear

    I have a Comp billet solid roller cam in my 340 with approx 50 miles on it, don't have the cam ID but it's definitely a billet cam. The engine was completely rebuilt by an experienced Mopar builder for another mopar guy, I bought it from him with only run time on the break in stand. All is...
  8. kenelder

    CNC machined Six Pack air cleaners

    Hello everyone, I wanted to share pictures of the new billet CNC machined Six Pack air cleaners that were just prototyped. One for each carb instead of a single oval. The filter area is larger than the carb throat area and the base plates are all machined with smooth "venturi" like curves into...
  9. kenelder

    A body rear shackle mount spacer

    I'm making some rear shackle mount spacers for my '70 Dart with super stock springs. Like most have noted, due to the arch the rear shackles are angled to the front of the car instead of angled to the back of the car. For mine, a half inch spacer will work, the spacer goes between the back...
  10. kenelder

    Build sheet power steering code?

    I am trying to figure out if my 1970 340 Dart had power steering. In the build sheet the last line section for Suspension- Steering has a number 7 typed in the Power Steering box. Not sure what that 7 means. Does anyone know? Not original engine (has a '69 now) and it's manual steering, but...
Back
Top