Search results for query: *

I just scored a pare of Dodge Magnum EQ heads New Zealand castings at a local swap meet here in AZ. the bowls are cut for a 1.62" exhaust valve and a 2.02 intake valve. They are brand new bare assemblies still in the boxes and were stapled shut. They have a website on the box but I can't get to...

I have a 65 Barracuda in the build stage. SS springs, 8.75 with a spool and 35 sline axles. I have a 65 B body A833 4 spd. with a trunnion to U joint adapter, scatter shield, hyd. clutch fork ram, Mcleod flywheel and clutch assy., behind a potent 360. Where is the weak point in your opinion.

I'm swapping my automatic to a 4spd. Question? If I put a center console in my car, do I still need the floor tunnel? Or is the console enouth to cover the cut out in the floor for the shifter. Guess now that I think about it, my question should be, does a 66 barracuda have a floor tunnel for...

Can you put a 66 or newer speedometer cable assembly into a 65 A-833 transmission. talking about the pinion gear, adapter and cable. Is there a big difference between the 2 years, will they fit or not.

I'm looking for the interior trim just below the big rear window, I believe it is plastic. Looking for nice daily driver condition.

I'm looking for a 68-69 barracuda formula S console chrome shifter. Would also like to have the floor hump if anyone has a car they are parting out or cutting up. I already have the console.

I have a 96 360 magnum engine with less than 100,000 miles on it and the engine runs good. Can I just build on the existing bottom end? My plane is a big Muta Thumpr hyd. roller cam, stage 2 EQ heads 2.02 in. 1.6 ex., roller lifters and rockers, Offenhauser tunnel ram intake, dual Holley 450cfm...

Well what can I say, it's a work in progress. Bought it in Nevada about two years ago, time, space and money are always an issue. But little by little I'll get it there. It was about 80% there, just missing an engine. Floors had no rust, just a little on the bottom of the quarters and some...

Will a 60's or 70's small block A833 bell housing fit on a 90's 360 magnum engine. If so what kind of clutch assembly setup would I need. This is going into a 65 barracuda, and the A833 is from a 65 B body (coronet). I have everything but the bell housing and clutch assembly. I'm using a...