Search results for query: *

I considered different types of piping and selected 1/2" copper pipe. Made a water trap out of same, very satisfied with the results.

Depends on what vehicle op is working on.

PM sent.

Found the air cleaner, but it's not what you're looking for.

I believe that I have four or six in a barn, some bare some complete. In Ohio so shipping would be ?? Message me if interested.

Loosen the pipe closest to the pump and go from there.

I've been using rechargeable AA and AAA for several years of different brands and I can't remember any leaking.

I have a complete 273 two barrel air cleaner but can't get to it now because of the weather, maybe next week.

Thanks to everyone who took the time to respond to this thread.

Anyone care to share their thoughts on this deal or company? Maxjax® M6K Portable 6,000 LB. Two-Post Garage Lift

They are, but as I understand, only at their stores. Information on their web site.

Summit Racing has two balancers to fit your engine for less than $110 each. You'll need a pulley.

You say that the slave cylinder moves, but is the clutch release bearing moving? If bearing isn't moving then the cylinder needs to either be rebuilt or replaced. Is release bearing and linkage in correct position?

What would it cost to ship the coil bracket to 44663 please?

Are the bearing retainers bolted tight against the housing flange?

Hey Cheap, I'm about 100 miles south. I'll PM you. Magnum.

I don't see where he said he had a plastic tank.

This works, as does the preventative spray. I've been using dielectric grease for the last decade or so, mainly because I have it and use it on other electrical connections.

Do not buy Chinese trailer tires. They're not called China bombs for nothing.

I don't know anything about the Timesert, but I remember using an oversized self tapping drain plug years ago that worked.

I bought a new 273 dual point Prestolite distributor from Plymouth dealer in 1966. The cap was tan and still is. Don't know what this means, just saying.

This is not answering the op's question and I hope I'm not hijacking this post. But...if the BH alignment was off, we would remove the dowels, align the housing and drill and ream for oversized dowels. This was on big Cummins powered trucks, never tried small block.

Check the gasket on the filler cap.

Thanks for your kind offer, sending PM.

Patching fender well header holes. Want a couple pieces big enough to use for patches.

the .60 over engine .060 over, maybe.

About 25-30 years ago my young neighbor died under his Mopar. He used to borrow the big blue jack shown in my post, but he wasn't using my jack at that time, because I had moved.