Search results for query: *

So to follow up. I dug into the body some with a wire wheel on an angle grinder. The frame rails and rocker panels seem quite solid. But the sheet metal has at least as much filler in places as expected. Mostly above the rocker panels. If I'm not shooting for perfection, or even necessarily good...

I think I'm leaning towards tackling it pending further climbing around under the car, double checking the front end, and getting a second set of eyes on it in person for a sanity check. I'll poke around for the information myself, too, but any suggestions appreciated for a 300ish+ horsepower...

No plans to restore it so not super worried about anything being correct cosmetically as far as trim. The valiant grille is actually growing on me. The stock Barracuda grille is kind of "busy." I was actually considering swapping the seats out with the pans for something with an integrated...

Just learning to weld but do have some mig and flux core welding equipment and no shortage of scrap to practice. I was thinking this might be a decent first body project, just don't want to start totally from scratch. Much more experience on the mechanical side having done at least one engine...

To clarify, my goals are basically to make it structurally sound to be safe enough to drive and then the engine swap etc. I'm not trying to do anything remotely show quality. Having looked around floor panels for this car don't seem terribly expensive and there are even some aftermarket rail...

My dad picked this 1965 barracuda up at auction and I'm mulling whether it's worthwhile to build. It would be my first mopar. It's actually moving under its own power with a slant 6 of unknown quality but doesn't look to have been on the road in a while and if I tackle it at all I would be...