Search results for query: *

Hi fellow Mopar fans. I am looking for a cam kit for a 71 318 engine. I want the engine to have some rumble to it, but at the same time I would prefer a cam for daily street use. I would appreciate any comments that may steer me in the right direction. I want to stick to hydraulic lifters.

Hello. I need help finding the correct Brake Master Cylinder for my car. It is a 1968 Barracuda 5.2 with 10" drums and no brake booster. I purchased one new on line with a 1" bore and it seems to take a lot of effort to stop. The old was was removed and lost during restoration in a shop...

Hello out there! I have a 68 Barracuda small block with a power steering pump that needs to be replaced. I am having a hard time finding a rebuilt pump. I fine plenty of listings for 1969-1972 pumps but not for the 1968. Does anyone know what is the difference if any between 1968 and later...

I think so? How much are you wanting for that little devil?

Hello there. I think that if you check the first few replys of this thread you will find photos of the retainer that I am looking for. Thanks.

Hello. I am looking for the metal strip which attaches to the header bow of a 67-69 Barracuda top. This item holds the seal between the header and the top of the windshield. Thanks.

10-4. Thanks for the input. Let's see what will turn up.

Thanks to everyone for the help. I don't have the retainer for the header seal. It is missing from my car. If anyone knows where I may find one I would appreciate it.

This is the header and seal. Am I putting a square peg into a round hole?

Hello out there. I would like to know if someone would post a photo on where the header seal that comes in the Soft Seal kit CH1024 or MD2116 attaches to the windshield header? I am putting together a car that was stripped and have no guide to go by. Thanks to all for your help.

This is a picture of the clips.

The screws run thru the snaps into the clip. The clip is solid on the under side as to not tear the top material.

Sorry I don't have a photo available. But they fit A and B body rag tops. They attach to the sail panel on the belt line and have a hole in them for the boot snap to screw in and hold the molding in place. I believe the years are 1967-1969. My car is a 68 Barracuda convertible.

Hey there. I am looking for some clips that attach the belt molding to the body. These are the clips that the boot snaps attach to. Thanks.

This is the retainer. My 71 Cuda had them but my 68 doesn't. I cannot figure out where they would attach.

No Mustang. The car is a 1968 Barracuda with power top.

Can anyone post a photo of the location for the two plastic lock retainers that lock the top down when it is folded in the well? Thanks.