Search results for query: *

KBs now made by UEM I think they come out to stock specs. Thanks

Hi its a 1970 340 just stock as its going to be a street engine. Thanks

looking to buy .020 replacement. pistons looked at KB243-20 any other good choices?

Thanks I'll check them out too. Thanks

OK Thanks I will check it out,

looking for a new replacement fuel tank for a 1970 duster 340 no vent tubes, any one know of a good quality tank ? Thanks Dale

OK Thanks I will more than likely go with that. Thanks again.

What is a good replacement master cylinder for a 1970 duster 340 disc/drums non power? Heard Raybestos MC36406

Thanks I was guessing about 1 1/2 inch but thats what I wanted to know. Thanks a lot Dale

what is the offset of the pinion from the center point of rear end ?

Hi just wanted to let you guys know that finally found location for light its on the back of heater control panel. had to feel to find mounting spot. Hope to never have to change bulb ! A REAL PAIN IN THE A** Thanks Everyone

Manual wire diagram says A/C or heater switch. thanks

Hi again just checked wire diagram in manual says A/C or heater switch. Thanks

Just looked at the wiring diagram in 1973 manual traced out to A/C or heater switch lamp. Thanks

Hi thanks for the answer Doesn't look like either place. I'll keep scrachin my head. Thanks

Hi its a non AC car. The wires are orange & black with a twist in bulb # 1815 Thanks for your time. No pic I can't download them. Thanks

Hi I checked but doesnt look like the spot no mounting area. Thanks I will keep tryin. Thanks again

Hi 1973 Dodge Dart Sport 340 replaced radio speaker and heater core light bulb is hanging loose below heater control its on a round push in socket ( looks like ) cant see where it might go. I see no bracket or mount. Cant find any thing in 73 manual. Thanks For Any Help

73 Dart Sport 340 low vacuum due to cam change what do I need to make change? I have a A body manuel brake rod all ready. This is a disc brake car. Thanks

yea these are held in place with a pin as the holleys were look the same only shorter. Thanks

Hi rebuilding my holley 700 DP stock fuel bowl vent baffles "whistle" is about 2 inches long, replacement AED #5897 are about 1/2 inch shorter can they still be used? Thanks Dale

Thanks

Thanks

73 Dart Sport 340 can a 4 pin be swapped in place of the 5 pin

Hi this is a new build,Compcam 280/280 480 lift,compcam ultra pro magnum roller tip rockers,1.5 ratio came with comp shafts oil holes not offset side to side as stock mopar. Pushrod length 7.670 inch. comp hyd. lifters.

Hi back again this time got my 340 to fire up but shut down quickly as rocker noise it looks as if some of the rocker cup adjusters are not oiling right. driver side looks ok pass side looks like 6 of 8 not wet have not removed yet hope to this weekend and check it better cups & pushrods. has...

Pulled them yesterday found 4 frozen took apart seen nothing unusual put back together seamed OK but I will not use them going the scrap pile. Thanks for the help from everyone.