Search results for query: *

I want to retain my 4 inch bolt circle

Hi everyone, I am looking at a 8.25 5-4.5 duster rearend my rear end is a 71/4 5-4 any options to make this swap?

Hi everyone, I am looking at a 81/4 duster rear end 4-4.5 my rear end is a 71/4 5-4 circle. any possbilities of making this swap ?

Hi good news i installed the repair kit all my plugs have some grey tan there even looking

thank you for your reply, your correct 16-176 rods 067-065-053 489 jets 120-689 on the back

thank you for your reply, i did straighten it, the bend was mostly upper i think it will work fine mainly if it doesn't bind should work. your correct i should wait after i install newrebuild kit filter, and try it before any jet rod changes. four plugs look like there getting there little tan...

thank you, I have read where the edlebrock rods will not fit the old avs old style, might be hard to find. are the metering rods the primary?

I took the carburetor off today, took the top off i have a bent metering rod passenger side. I didn't take the rods out first before removing top it came apart just so easy i lifted the top off not sure how it got bent, there is corrosion green looking close to the top. this is a brand new 4636s...

I have read somewhere that the intake delivers every other cylinder, if that is the case then could my carb be delivering more on one side? also haven't taken carb apart yet to check jetting size also read on a carb site that some had a different jet size on one side than the other

four cylinders look good

yes i had the crank turned and assembly balanced

Hello everyone, I have a 1966 plymouth barracuda that came with a 273 automatic two barrel. I did a recent build on a 340 and rebuilt my 18 spline automatic as well. I need to go into detail about everthing i did so you can help me with my question so you know what i got. I built this motor to...

I have been reading the forums on here on front end rebuilds and have picked up some valuable information tricks new ideas, there is a lot of discussion on making sure your car is weighted upond torquing bushings. your bushings are designed to travel the distance motion through out its travel...