Search results for query: *

Hey Guys, I'm sure this has been covered before, but was wondering if there's a typical number of rotations that a manual steering box should turn? I was working on centering the number of turns per side (Left vs. Right). The manual steering box only has a total of 4 1/2 total turns of the...

Hey Guys, Need some help on how to remove the ignition switch from a 68 Barracuda. Assuming it's the same for a Dart... Looking to remove the entire switch unit to swap the "Key" assembly. Ignition and doors were keyed different when I bought the car, so I purchased a matching ignition and...

Hey Guys, Need diagnostic help and list of things to check... Have a newly rebuilt 340 engine and can't get it to start. It's getting fuel and spark. Tries to start and backfires through the carb. It has 145-150 lbs. of compression in each cylinder. Used pressure gauge to ensure...

Selling 318 Short Block for $150 OBO. Accept cash or PayPal. For Local pick-up only; Located in San Jose, CA. What I don't know: Miles on motor? Condition of bearings or other surfaces? Cam specs? Any other internal mechanical specs? What I do know:Motor was running before pulled from...

Working on converting my brother's 68 Barracuda from a B&M Pro Stick cable shifter to a stock mechanical floor shift unit. Can't figure out the bracket and linkage on the trans side. The car has a 318 and 727 trans and after further investigation, it looks like the trans if from a 75 truck...

First time attempt to swap ring/pinion and rebuild an 8.75 (489 Case) and need some help and insight. Specifically, with setting pinion depth and installing large and small end bearings. Let me explain my situation and list out questions: Situation: Ring and pinion are 4:10 Richmond and have...

So, I was rebuilding an 8 3/4 clutch style posi-unit and much to my dismay, found one of the spider gear shafts broken. Does anyone know if I can weld/repair this or am I hosed? Not sure if anyone sells these as replacements... Any help would be appreciated...

I know this question has been posted before, but didn't see a response. Rebuilt my 742 (Clutch Style) sure grip and aligned both sets of splines. After running the car, pulled axles and now the splines seem to be misaligned. Can't get the axles into the second set of splines. Is there a...

Need some help w/my 833 4-speed. Bought from a local sawp meet and installed as was. Adjusted clutch shifter rods and fork linakge several times and appears to go into all gears, 1-4 & R. When clutch is let out, car rolls either forward or back slowly. Under load, there's a high pitched...