Search results for query: *

I have a set that I'm removing from my 68 Dart. They've been in the car for a few years but very few miles have been put on the car. I'd refer to them as like new. I'm replacing them with -1" springs from Eaton and using a slide-a-link system as well. I'm located in the SF-Oakland Bay area. You...

I have one listed for sale. $45 and that includes shipping. PM me if interested.

I'm pretty sure I have this. I'll look this afternoon and send a picture later today.

I have a used Mopar Purple cam with these specs: Avg. Dur 268/272 dur @ .050 228/231 Lift .450/.455 center line 110 Rpm 1500 - 5800

Here where I took the measurement.

I have a few of these, just need to confirm the length. I'll let you know by tomorrow. Do you just need the bolt? Because I have the nut and hold down washer as well.

I’m trying to confirm. I know it was used with hydraulic lifters.

I have this used cam available for $80 Mopar Purple cam 1136 Avg. Dur 268/272 dur @ .050 228/231 Lift .450/.455 center line 110 Rpm 1500 - 5800

Here’s what I have. By the way, the base I have has the same measurements as the drawing in the earlier post.

I will check on that as well.

I have the bolt, nut and round hold down plate. Let me measure it to make sure and I'll send pics later today.

I have one that came from a 1968 Dart with a 273

Thank you. I found one last week.

I have a Performer RPM already, I want to run the Air Gap.

The 7577 is for the 5.9 Magnum only. The 7576 is for the 318 340 360 LA engines/blocks/heads.

Let me know, thanks!

Looking for new or used Edelbrock Air Gap 7576 intake manifold for 318 340 360 small block. Summit is out of stock until July and I would need one sooner. I was going to sell my RPM Performer with my 318 engine but if I don't anything soon I'll end up using it. Thanks!

Are you asking where do they exit within the engine compartment? Hedman has installation instructions on their site. Not sure what A-body you’re putting this in but older posts on this site say these are the ones that work, the cheaper alternative to the TTI headers.

I have these Hedman 78500 headers for sale. $250 plus shipping from NorCal 94544

Where are you located in California? I’m in the Bay Area just south of Oakland. Between my friend and I, we may have everything you need.

Did you receive the set yet? If not I have a pair available.

Let me know the inner and outer diameter of the ring. The NOS one I have lists the application for 1962-1966 but may fit yours.

I have one that came out of a 4 door 1968 Dart, 318, 7 1/4 rear, 904 if that's the same size.

I'm installing a 4-link on my 38 Dodge pickup so I'm not using leaf springs, but the length of the rear is important. Here's a small section of an article I'm basing my information/request on: There were several different rear-end housing widths used on these models. All measurements are from...

I need an B-body 8 3/4, 1964-1967 only. The length is 59 1/2 " from drum to drum. The reason is that I do not want to cut down a longer housing/axle. I prefer a complete rear assembly, but it does not have to have drums. Center section would be great too but not completely necessary. I'm...

Let me know if you're interested.