Search results for query: *

https://www.megapartsusa.com/proddetail.php?prod=101-ABK795

@cuda67man

Did you check Speedway motors?

Bill and Rose Evans do a lot of harnesses and they are good quality but dash harnesses are one thing they don’t do. M&H are the ones that do the the dash harnesses sold by Year One and they are the only distributor for M&H.

Looking for the water temp gauge that matches the ones pictured below. Thanks

Hey Steve, You may know this already but the handle pull is reproduced. Not cheap though. MA1827 - 1967 Dart, Barracuda, Valiant; Glove Box Handle; Hardtop; w/o Lock Cylinder

The opening in the door for a “standard” pull handle is a screw hole with a second hole that locates the handle via a small pin cast in the pull handle . The door for a locking latch has a hole big enough for the cylinder to pass through.

I have a spare that I made at the time and looks as if there’s not a left and right unless I just put two set screws in this one.

they are left and right specific best i remember its the set screw position for each.

I think I still have one you could use I’ll take a look around mid day today and report back.

them are tough find for sure and when you do find them you get the same pot metal ones that broke before. I made two out of cold rolled steel good luck in your search.

aka “spire nuts or chimney nuts”

Them are called U nuts

@jsjs1212

If looking for glass only there’s no difference. first pic is 67’ only see the red circled bracket? second is 68 up

67’ vents are one year only

if you don’t find used here are some Mopar 11.75" Disc Brake Slider Caliper Brackets

Mark, I should have an extra set of plates but I don’t have the U bolts.

73’ up spindles 80’ volare calipers and hoses 11.75 rotors and manual 15/16 bore master. While I appreciate the feedback I’m good on the parts I’m using just need a factory proportion valve to complete the swap. I’m fully aware of adjustable valves and later blocks with proportioning and...

this isn’t a “kit”

the car had drums originally and are what would have been standard.I removed the drums and am converting it to discs

69’ bee with single piston calipers and rear drums

Looking for a factory original or correct rear brake proportion valve it’s the one that goes in the rear brake line and is attached to the inside of the left frame right under the floor pan. Here’s a pic for reference please let me know if you have one available Thanks

I took a look and I don’t have a passenger side LCA sorry

pretty sure I may have one will let you know this evening

Lowers Without the sway bar tabs are the same 67-76

Al I have both parts you need i’ll PM you

There’s a chance I may have that too. I’ll let you know what I find tomorrow evening.

I think I have one AL I’ll take a look tomorrow when I’m back in the shop.

Why not just call cometic and have them made?