Search results for query: *

Take the cap to a Machine shop and have it filled with spray weld. Then have it drilled, threaded and reface the pump surface. I would bolt and torque it to an old block we have when welding it. Spray weld is the correct way . You won't even see where it was welded. And leave the engine in...

The 7 1/4" rear absorbs less power parasitically than larger (8 1/4" or 8 3/4") offerings. To maximize power, the smallest axle housing that can handle the job is the best one for the job. I think you already know this, though.

3.910 is the what I set my digital caliper to. Then use my telescoping gauge 1” down I get 3.910.

What model and year Duster. Is it a 70-71 rally dash car

Wow. I didn't think these rear ends were absolute trash that coukdnt be rebuilt when they fail. Chrysler put tons of these in A bodies and I've seen people state they lasted a couple hundred thousand miles. If they were such junk why did Chrysler put these behind 273's and 318's knowing they...

It suits the moment

If I never have to go back to Chicago, I'm sure not going to miss it.

It absolutely will ! Keep it, and now mail me the old one……. :-)

Leave the clamps off of the rear section. You don’t want them there if you’re going to hit the drags anyways.

I had thought about a bit of angle milling to raise it. I do have a thin aftermarket steering column (actually just a thin shaft) & the coupler is narrow too so I might be good there. if a bit of grinding on the top of the box/bottom of the manifold & maybe a bit of angle grinding doesn't cut...

3.910 looked into that. About 2300 on that. Will have to wait on that great suggestion.

Never tried it but must be good.

How long can Edelbrock continue to cast in California if burger flippers are now way over 20.00 an hour

"Clean up," the '71 block by 0.040" to 3.950. Get yourself a new 4" crank. You now have a 392 WEDGE. Get yourself some of these badges and replace your "V8" badges.

420 Strain IPA

One more question are your wheels 4 inch bolt pattern or 4 1/2 bolt pattern/spacing? Thank you.

What is it?

This is an Assorted Lot Of 1960's/70's Mopar Engine Accessories Brackets. They are all original, not china knockoffs. They are in good condition, just could use a cleanup. $45.00. Local pickup, or buyer pays shipping.

Are you replacing the rear main with the engine still in the car? Pull it. The job will be cleaner and you'll be able to see what you're doing.

Fixed it for you.

Ha! Thank you!! :) :)

Actually, when I had that job, I always carried an old single action .22 revolver loaded with birdshot. The occasional ugly spider wasn't as bad of a deal as the occasional rattlesnake. This was the chlorinator building / control room of the local water system. I was the operator. Building was...

Same. When I was a kid, 8-10yo, my mom always had trouble backing up our boat so my dad taught me how to do it. By 12 it was my job when we went to the lake. My brother learned how to drive the boat on/off the trailer. Looking back I think it was my dads way of making us do it so he could have a...

A little early

This is a OEM 1970's Small Block Throttle Return Spring Bracket. It is original, not a china knockoff. $15.00. Local pickup, or buyer pays shipping.

Shhhh

Unsuspecting Ground Hogs? :lol: