Search results for query: *

Do they light up

Demonracer, thank you!

All he likes to do is troll, start 318 strawman arguments and if there's no active 318 thread he'll dig some up lol, then play victim when people argue back. As for being /6,273,318 forum, my guess 80-90% of A Bodies came with these engines.

With no center seat belts, you can probably use the C 11 bolts.

Sounds like the track was kissing their *** big time probably looking for sponsorship money. Congrats with the win.

Can you post a picture

Looks like I shoulda posted that chart earlier, sorry .

Here are two plugs from an engine I’m tuning. The plug with the shell on is where I started. Way fat. The plug with the shell off is the last pull yesterday. It’s close but not there yet. There is probably 8-10 hp left with carb changes but it’s still a bit fat. I could put fuel back in it...

There looks to be a smaller socket nested inside a larger socket. See my original post. These are factory pieces.....not like the one in the picture above. I'll send a picture, yeah that's it, a picture!

Hi All The needle on 65 barracuda temp gauge fell out. The little red needle piece……. Does anyone make new ones or does someone have one for sale. Any info is greatly appreciated

Hood Prop to mimic a 1969 1/2 SB A12

Nice Non Cap 273 Air Cleaner with base and pie tin. Not show quality but very nice driver. Does have some speckling/scratches and last photo taken from 4" away. $200 plus the ride. Location - Charlotte, NC

No Silicone needed. :thumbsup:

Yeah, I've seen them. I want one, just don't want to spend $500 for a grille. lol

They fit just fine!

overall good condition.

bought the low gearset for my 904 from them.

Thank you.

Some swap pics

Camby Indiana

I love everything about this car and build. Well, except the drive, because he's young and a much better driver than I am, for now :lol:

It does still have power steering. Rear wheels are 18x11, tires are 295,45R18 (Custom Length for the axle to fit the backspacing) Front wheels are 18x7, tires are not the final size I will be using. I have a taller side wall and wider tire to put on.

I see you have a swivel on your hook-makes life a lot easier-doesn't it?

Where is A & A located? Found several on an internet search but would like to get the correct shop. Thanks.

he did my front grills and bezels , ''great job' , look new !!! famous bob approved /lol

newer engine as in what? modern hemi? big job and can be pricey too. why not redo the 318 or stick a nice running 360 in it. being its already got a small block in it would make it the cheapest route.

I have the same question as the OP but for a 1975 bench seat Duster. Looking to replace the jury-rigged setup currently in the car with three point belts (no center belt). If anyone knows the bolt size for that year, or maybe even have the bolts, please let me know. TIA

If anyone needs a nice back glass for an early Barracuda, there is one in the Lincoln NE U Pull It. I didn't know if they reproduce them or not. You would have to be fairly close I assume.

Let me put it another way......I don't get it! :wtf: