Search results for query: *

I will be going on my 4th set of valve cover gaskets on my 360 w/stock stamped VC’s, not the chrome ones. Dealing mostly w/seepage. I initially had the Moroso Blues on when I primed the engine and it leaked out of the right bank, middle hole on the exhaust side. Switched to Felpro corks, 3M...

Just finished up the 360 rebuild w/a stock center sump pan, NAPA Gold 1068 filter and will be installing a new oil dipstick. To verify if it is reading accurately, I'll fill the block w/5qts, spin the pump to circulate in the oil filter, let the oil settle, then check. My question is if the...

I'm ready to order specific length push rods for a 360 LA, using Comp Cams Pro Roller Rockers, Comp Cams XE268 hydraulic flat tappet. Seems to be a limited selection of ball end push rods for a 360 LA, the majority of them have oil holes. Since it oils from the rocker shafts, would it hurt to...

I'll be getting the block back from the shop this week. 72 360, stock crank n rods, KB107's, stock heads, new valve job, heads mildly ported, block n heads were not cut. I'll be installing Com Cam Pro Mag Rockers and Comp Cams XE268 hyd flat tappet cam. I'll need ball to ball end push rods...

Need to purchase an engine gasket set for a 360LA. Can anyone tell me what head gasket is supplied in the Fel Pro kits? I need Fel Pro 1008, .039. Thanks

69 Dart, 73-360, 4 speed, 3.55’s, primarily street driven. KB107’s 30 over, estimated comp 9.5 to 1 pending head gasket thickness on pump gas. Shootin for approx.. 400 hp. Stock crank and rods. Stock heads/valves, valve job, new guides and mild porting. Eddy Performer RPM intake. Comp Cams...

Need to swap out my spool motor mounts. Should I switch to poly or stick w/the traditional rubber?