Search results for query: *

I have a .040 340, iron "J" heads, that has been the engine from HELL. It came out of a 71 DEMON and I think it is POSSESED. Be Cool radiator, AC water pump, TTI headers, Air Gap intake, electric fan and the March Pulleys It was built about 8 years ago, installed in 2004 and car on the...

It might not be in and I'm hoping that the next time I go over that it was so excited to be home it jumps in while I'm gone It should be back in the car in the next week, now to focus on getting it running in the car

well after a few months being completely rebuilt again the engine was started yesterday. They show on TV in just a minute or two an engine set up on stand and hooked to dyno. Well I got there at 9am and by noon we were about ready to run. Ben (ProMax) normally has his BB on the stand to...

The balancer on my 340 is the original from 1971 and the rubber is looking old, so it was suggested I change it Now this is just a street 340, not building it as a race motor, but want it to be respectable Looking at a few different sites but Mancini has the most shown for my motor on the...

I stopped by and seen my short block is together. He lined the cam and crank up with the gear set. This is a street car and probably will take it down the track once if I think it runs like it should. Now how important is it to actually degree the cam in? or is setting it with the timing...

I was at the shop today looking and discussing my engine It should be back together in the next couple of weeks and I'm wondering, "should I get a bigger oil pan?" I have a 67 Dart with a factory small block 71 K Member and a 340, 4 speed and will be installing TTI headers (hopefully) Plan...

Gapless rings, I know they make them, wondering if any of you are using them and input on the use of them I have had problems with my 340 from the beginning. 1st I thought it was possessed since the short block came out of a Demon. Now I think it might be the chebby guy that built it at the...

I have a 85 dodge van with a 360 4 barrel. I figure that the engine and trans is worth more than the whole van. Just trying to figure if I should keep the engine or not. I know that the factory switched to roller cams sometime in the 80's Would this block be a factory roller cam?

I'm thinking crate motor instead of reinstalling my 340 in my Dart. Has anyone heard anything about BLUEPRINT ENGINES? I seen an ad in Mopar Muscle and they have a 408 Stroker for $3,599.99 Claim 375 HP and 460 Torque. They have a 30 month 50,000 mile warranty for street engines. Is this too...

I have tried to get info on the roller lifters from Comp Cams and they have not sent or told me anything. My ? is What mods have to be done to the block to install roller lifters in a 1971 340 block? I have been told they have some direct replacement lifters for this from a friend. I have...

was needing to know what the canister under the turbo on a 95 Dodge with a cummins is called. Has heater hose hook up on the front of it. Thought it could be the heater for the cooling system (got one that is kind of like that on the backhoe) then thought it might be for the fuel heater. But...

I have the 340 out of my car. It likes to bend parts for now reason. I have a guy that said he would check and repair it but he is a Ford guy. I know he will research and is very good at everything he does. What I got to thinking tonight is I need a book for info he might need that isn't in a...