[FOR SALE] 12.5 TRW 340 Pistons

Mopar Mechanical Parts For Sale

Thread Status:
Not open for further replies.
  1. whitepunkonnitro

    whitepunkonnitro Well-Known Member

    Messages:
    14,799
    Likes Received:
    935
    Joined:
    Dec 6, 2011
    Location:
    Murfreesboro Tn
    Local Time:
    11:32 PM
    Contact Seller
    Lot of 5 TRW L2322 340 pistons. .030, all in good condition.
    Use these to start a set, or keep them as spares.
    Asking $40 plus shipping.
    Thanks FABO!
    2017-05-17 08.29.19.jpg
     
  2. whitepunkonnitro

    whitepunkonnitro Well-Known Member

    Messages:
    14,799
    Likes Received:
    935
    Joined:
    Dec 6, 2011
    Location:
    Murfreesboro Tn
    Local Time:
    11:32 PM
    $39
     
  3. oldkimmer

    oldkimmer FABO Gold Member FABO Gold Member

    Messages:
    16,993
    Likes Received:
    5191
    Joined:
    Nov 11, 2006
    Location:
    Kindersley, Saskatchewan,
    Local Time:
    11:32 PM
    R u sure those arn't the 10.5 pistons? Do they have 5/16ths ring grooves? What is the compression distance from the top of the pin to the piston top? I may have a use for them. Can u post a few better pics of them. Thanks. Kim.
     
  4. whitepunkonnitro

    whitepunkonnitro Well-Known Member

    Messages:
    14,799
    Likes Received:
    935
    Joined:
    Dec 6, 2011
    Location:
    Murfreesboro Tn
    Local Time:
    11:32 PM
    Info I posted is from googling the L2322 number stamped on top.
    They do have less of a dome than I would expect for that CR, so they may have been milled at some point
     
  5. whitepunkonnitro

    whitepunkonnitro Well-Known Member

    Messages:
    14,799
    Likes Received:
    935
    Joined:
    Dec 6, 2011
    Location:
    Murfreesboro Tn
    Local Time:
    11:32 PM
    $38
     
  6. Jax340Dart

    Jax340Dart Well-Known Member

    Messages:
    78
    Likes Received:
    38
    Joined:
    Aug 28, 2015
    Location:
    Albion Pa
    Local Time:
    11:32 PM
    Tony, Im pretty sure the domes have been milled off on those pistons. The CR on them is probably around 10:1 depending on cc of the head
     
  7. Demonracer

    Demonracer 71 Demon 00 Ram 16 Chrysler 300S 05 Caravan FABO Gold Member

    Messages:
    3,929
    Likes Received:
    1846
    Joined:
    Jan 31, 2010
    Location:
    Cleveland, Texas
    Local Time:
    11:32 PM
    Those have been milled a bunch, I just located a set of standard bore L2322 pistons that have the pocket an inch across from the mill mark in the center of the piston & the dome is quite a bit taller. Just FYI.
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalize content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.