D
Deleted member 38666
Guest
Members, I am cloning a 65 Dart Charger, and I am going to "cut and weld" in the notch for the single exhaust in the rear valance. The notch, I understand, is roughly 1.75 inches high by 6 inches wide (correct)? What I need is the measurement at the bottom of the rear valance from the point where the rear valance meets the rear quarter on the driver side (rear valance/rear quarter seam) to the left hand side (driver side) of the notch at the valance bottom. Can someone help me with this dimension. Thanks. Old Dart