[WANTED] 1970-72 MOPAR A BODY OIL PAN WITH 294 STAMP
- Thread starter bahamabecomb
- Start date
-
- Status
coloradohill
Well-Known Member
I have two small block pans. One is this 394.
[/URL]
Not sure what the other one is. Does it need to be a 294?
I’ll check the other one
[/URL]
Not sure what the other one is. Does it need to be a 294?
I’ll check the other one
I have one - I can’t remember if the stamping is 294 or 394
I also have one. Cooked , Primed and no road or floor rash. It was kept from my original 340 street engine but I left the build to my son. I ended up with another race engine, He did not use the factory oil pan.
I also have dirty pans much cheaper. Off engines we bought that were set on the floor after removal and slid around. That is where most of the pans get damaged. A clean OEM pan is getting hard to find.
They do remake them but the bolt holes turn into cups if over tightened . The metal is just not the same quality.
I also have dirty pans much cheaper. Off engines we bought that were set on the floor after removal and slid around. That is where most of the pans get damaged. A clean OEM pan is getting hard to find.
They do remake them but the bolt holes turn into cups if over tightened . The metal is just not the same quality.
Do you have a picture of the primed one? How much do you want for it? Thanks
Are the bolt holes good all around? I'm hoping for one that is not dented but I may come back to this.
drduster
Active Member
The bolt holes are nice. This pan isn't dented. Any depressions you see are original.
Here’s the 294 oil pan I have
How much do you want for it?
- Status
-
