[Found!] 49.27" Driveshaft

[Machmeter1]

Looking for a drive shaft for my 69 Barracuda. According to the service manual, a 904 and 8 3/4 combination came with a 49.27" driveshaft.

Thanks, Wolfgang

 

[69FBCuda]

I pulled this some fabo somewhere.

Replacement?
2852206 1967-69 2.75 48.60 904 8-3/4 273 318 Barracuda Valiant
2852206 1967-69 2.75 48.60 833 8-3/4 273 318 340 383 Barracuda Valiant

Edit:
Found it, thanks Rainy Day aka Princess Valiant

ok, wow driveshaft length chart problem

 

[Machmeter1]

That's out of the 69 service manual:

 

[Machmeter1]

My transmission is not in yet, but I am very positive that the drive shaft I currently have, (44.88) will be too short.

 

[Mike69cuda]

Don’t forget the large & small u joint difference as well.

 

[Machmeter1]

Don’t forget the large & small u joint difference as well.

Thanks for bringing this up, how much would that be?

 

[HemiSSDart]

The 44.88 inch driveshaft is very desireable. Sold one for $200 last year. As far as the 7260 and 7290 u-joint difference there is a dual pattern one made that is very strong, I used it in a 69 Dart drag car years ago when I had to change the pumpkin...

 

[Machmeter1]

Well, I have one in excellent condition, rust-free, balanced with the transmission slide in yoke (727) and U-joints. Would gladly trade or sell it, because I can't cut it longer

 

[Mike69cuda]

Thanks for bringing this up, how much would that be?

I don’t remember the dimensions but the small one, the 7260 has caps that are quite a bit smaller than the 7290. Very obvious side by side. As mentioned earlier, you can buy a u joint that is half and half. Or you can change the yoke on the rearend. That is what I did because I had one available. Didn’t have to buy a u joint that way.

 

[Machmeter1]

Still looking for that driveshaft...