[SOLD] 60’s era floor shifter

[Docmcg]

I’ve had this shifter sitting on the shelf for quite awhile, with no project vehicle to put it in. I think it came from a ‘65-‘66 Barracuda or maybe even some B body model car. It apparently mounts in a floor console. If it’s something you recognize and could make work for your project car let me know. Not show quality by any means, but not a piece of junk either. It does function as you’d expect. No cables, just what shows in pictures. I think $75 with free shipping is reasonable. Let me know. I’m located in central CA 93292. Thanks, Steve.

 

[RustyRatRod]

That looks like a dash mounted shifter from an A body van or truck.

 

[leechris81]

I’m interested in the shifter but it won’t let me PM.

 

[Docmcg]

It’s definitely not for an A100 truck! I already found that out.

 

[Docmcg]

Hey leechris81, I just sent you a direct message. Let me know if you get it.

 

[leechris81]

Hey leechris81, I just sent you a direct message. Let me know if you get it.

I tried sending one back to you. Hopefully it will work that way. Thank you!

 

[rbkt65]

I agree with RRR. If it has attachment for 2 cables, it is an "a or b " body. If only 1 cable truck, either A100 van or Sweptline pickup. I have 3 of that type. 2-2 cable type and 1 1 cable. I know that the 1 cable came from a Sweptline. The crooked handle gives it away.

 

[jas0162]

Looks like one from an RV.

 

[hemidart67]

That looks like a dash mounted shifter from an A body van or truck.

I was going to respond with the same thing.
Looks like the same shifter as the one in my buddy's 68 pick up

 

[rbkt65]

Response #8 could also be correct. As I said, the crooked handle is the dead giveaway.

 

[Docmcg]

I don’t remember where I got it. Definitely only one cable though. Shifter bezel is flat on the bottom. Does not fit A100 dash profile.

 

[Docmcg]

SOLD

 

[rbkt65]

need to mark sold, if it is sold.