[FOR SALE] 8-3/4 742 chunk

-
Status
Not open for further replies.

Scotty85

Active Member
Joined
Mar 20, 2016
Messages
39
Reaction score
25
Location
Lumberton
Rating - 100%
1   0   0
Contact seller
This is a Mopar 8-3/4 center-section (chunk). This is a 742 case with 4.10 Richmond gears, billet 1350 yoke, billet caps, and billet Richmond full spool (35 spline). I just put a new pinion seal in it also. I have the 35 spline Moser axles that were in this same rear end as well. They are stock length and have green bearings and flanges on them already. Bearings are good and axles are in good condition. Bolt pattern is 5 x 4-1/2 with 3-inch screw-in studs.

Asking $975 + Shipping for the 742
Asking $300 + Shipping for the axles

I am willing to sell the complete rear-end with Moser 35 spline axles minus brakes for $1800 OBO.

Scott
PXL_20220119_021955452.jpg
 
Last edited:
Status
Not open for further replies.
-
Back
Top