Have a 904 trans that has a very small hole where the rear rod attaches. My rear rod has a clip on it that would snap on to a ball stud. Has anyone seen this type of a mount, I haven't.
904 Trans Control Lever
- Thread starter flashsuperstar
- Start date
-
Post a few pics. Kim
Here is the best I am able to take. The hole measures .24
So u have a 727 lever that won’t be right for the 904. Post a pic of the rod end. What year ad d model are u working with. Kim
1972 Plymouth Scamp, 360 engine 904 trans
Show the rod. Does it have a rubber bushing on it? Kim
Originally the vehicle was a slant 6 (225) with I believe a 904. The rear rod I believed I removed is the one pictured, however it does not have the end for a rubber bushing as I have seen on all other rods. Any info would be helpful and appreciated.
This rod is for a slant 6 and won’t work for u. It is for the kick down I believe. I’ll look for some linkage when I get home tomorrow afternoon. Kim
Thank you
I never had a chance to look. Can u message me on Tuesday? Thanks. Kim
Will do
Replying back to you as requested, have a good day.
-
