70SwingerGT
Active Member
PENDING trade w/Garrett Ellison.
I had a truck Dana 60 cut down to 'stock' A-body spec width and 43" C2C perches and new housing end flanges. My plan was to use it in a 66 Barracuda Formula S, but I have since moved on to building my D100 truck (parts for that are waaaaaaay easier (ie: cheaper) to find rather than this damn 1-year only Barracuda).
Anyway, no snubber provision as I didn't want it anyway - was planning to use Cal-tracs, which are better than any snubber out there. The yoke is inside the case. No guts, so, the sky is the limit as to what you could put in it. Professionally done. Perfect poor man's Dana build lol.
I have $900 in it. That's what I'm looking to get. Shipping is on you OR pick it up in 32148 N. FL.
PM me here for any inquiries.
I had a truck Dana 60 cut down to 'stock' A-body spec width and 43" C2C perches and new housing end flanges. My plan was to use it in a 66 Barracuda Formula S, but I have since moved on to building my D100 truck (parts for that are waaaaaaay easier (ie: cheaper) to find rather than this damn 1-year only Barracuda).
Anyway, no snubber provision as I didn't want it anyway - was planning to use Cal-tracs, which are better than any snubber out there. The yoke is inside the case. No guts, so, the sky is the limit as to what you could put in it. Professionally done. Perfect poor man's Dana build lol.
I have $900 in it. That's what I'm looking to get. Shipping is on you OR pick it up in 32148 N. FL.
PM me here for any inquiries.
Last edited:
