That certainly seems to work pretty good. Will it fit under the k member in the front? If not, I'm sure it'll go under the side and grab the frame rails in the front. Probably even under the lower control arms. I think you done good!
Anyone know of an electric, pneumatic, or hydraulic floor jack?
- Thread starter MrJLR
- Start date
-
No matter which ones you use use some good jack stands.
MrJLR
Built, not bought
Collapsed is 6.5" and extended around 17"
MrJLR
Built, not bought
Yeppers. ...fit under the k-member easily!
That's pretty cool! Can you give a measured height at its absolute lowest position? I might have to get me one, too.
MrJLR
Built, not bought
Yes....I have a pic of that on my phone....,I'll post it in a moment.
It was about 6.5"
No way in hell that'll go under m k frame, but that can be easily worked around.
MrJLR
Built, not bought
MrJLR
Built, not bought
It went under my k-frame....I lifted it and got all 4 wheels on my wheel dollys....
MrJLR
Built, not bought
Pulling the engine out and stripping the car to go to paint
It'll go under mine, too once I get the tires on it I want and get it at the ride height I want. That's pretty cool man. Thanks for all the info.
MrJLR
Built, not bought
Absolutely. Any time I find a good tool that actually does what they claim, I like to share!
Jeff
Have owned this Gray Portamatic Air Lift, use the heck out of it.
Raise up the front end, put jack stands under the car. Then raise up the back end, has safety stops on the jack, but slide in a second set of jackstands under the rear axle then you are good and can pull the air lift jack out of the way.
40 years of service, has never failed. Lube up the slides with a little WD-40 every once in a while. Will probably last another 40 years too.
☆☆☆
-
