Bell housing needed

-
Status
Not open for further replies.

dodgewade

Active Member
Joined
Dec 9, 2009
Messages
43
Reaction score
0
Rating - 0%
0   0   0
Contact seller
I need a bell housing that will mate up a 318 engine with a 81-86 3 speed w/overdrive transmission. The trans is a A833 4 speed that Dodge just converted to a 3 speed w/overdrive. I really think most any bell housing that will fit the engine and a A833 trans will work. The center hole is 5 1/8". This is not a big thing, I could have the hole rebored.

Thanks
 
I have one for a 23 spline 4 speed car. i believe its a 69 bellhousing which would fit your 318. I will take pics tomorrow and measure the hole for you.
 
I have one for a 23 spline 4 speed car. i believe its a 69 bellhousing which would fit your 318. I will take pics tomorrow and measure the hole for you.

the ID will be too small unless he wants to bore it.

If he doesn't want yours, I know of someone local wanting just what you have.
 
I have one for a 23 spline 4 speed car. i believe its a 69 bellhousing which would fit your 318. I will take pics tomorrow and measure the hole for you.


Boring hole is not a problem. Send pic.
 
If you bore the hole I'm not sure you'll still have a place to mount the fork pivot. I think your best bet would be to get the prober bell housing for the OD trans.
 
Status
Not open for further replies.
-
Back
Top