Big Block Cylinder heads

-
Status
Not open for further replies.
I got some 452s, 346's, and 906s. All came off running motors. Then I ported them and lapped in the valves on the 346's and 906's, some of the valves on the 452's were junk so I chucked them but have replacement stainless steel valves if interested. Anyways, the 346 just need to be cleaned and have the right springs for your cam, the 906 could use either bigger exhaust valves or hard seats, and the 452 should get new valves and a grind. I will sell the 906 for $150, 346 for $75 and 452 for $75, all plus shipping. Email AmoB64@msn.com if your interested!
 
well i'm looking for more of something that I can just bolt on.
but, if i decide otherwise i'll send you an e-mail.
 
I got some that will be ready to bolt on but Im like $650 into them and would need that out of them. They are 906's with hard seats on the exhaust and 1.84 SS valves, ported, magged and hot tanked, fresh valve job, need your springs and retainers to bolt on.
 
Ive got a a set of 906 heads that have a new valve job onthem and have been minorly ported and gasket matched, nice heads 225.00 and shipping.
 
got any pics?
were they ported by a shop or did you do em?
 
Status
Not open for further replies.
-

Back
Top