Located in the Pittsburgh pa area. I have for sale a set a Chris Alston's 32" ladder bars and 2 of the 4 brackets. The ladder bars have never been used. They were mocked up on a duster and the car was rolled in and out of the garage. Ended up going with a dana 60 and different setup than ladder bars. These have been sitting at the shop for a few years now and I really need to clean up. Asking $155 plus shipping obo. Will just sell ladder bars if you don't want the brackets. Thanks
@70aarcuda They are at the shop I'll swing by tonight or tmrow after work and get those measurements for you. @killerslant replied to your IM. Thanks
@70aarcuda From center of the main eye following the line of the ladder bar to the center of the 2 outer eyes I got the following measurements. Bottom eye is about 26 3/8" (Please note this was with the adjuster and the eye threaded all the way in) Top bar showed about 30 3/4" length with about 4 threads showing. If anyone needs anything else just let me know. Thanks
@bob mCcarty I can't speak for how your car is setup. But typically A body mopars are backhalfed for use with 32" ladder bars. These ladder bars (because of the brackets) are the standard 32 inches and measured from the center of the front eye to the face of the axle. Hope that helps and price reduced $115 obo plus shipping.