Do They Make A relocation block for M/C For The Early A's

[MonkeyMadness]

Whats are you guys using??
-I have an early A-body 1965 Barracuda and have a CPP Master Cylinder w/7"booster and it is a bit close to my Valve cover. I would like to shift my booster over a bit but I don't know which relocation kit/block to use for the early A'
-I've been looking and I keep finding the same block says for "68 A-body only" through jeggs, summit, and Manicini
I need it to fit the 65-66 A-body!?! ugh

 

[Professor Fate]

It will physically fit, but I can't vouch for the offset with your booster setup, if it will move it too far over and into your inner fender apron. These are based on the units used on the '68 SS Darts and Barracudas to clear the v/c of the hemi, thus their designation in the catalogs. Just remember if you use one, it also spaces the mc & booster farther out from the firewall, and you could run into brake push rod length issues. Plan wisely. Many factory sb valve covers were dimpled at the rear to provide more clearance, but not all. If yours are not, it may be easier to find another set of vc s and swap those on.