[SOLD] Early A Body Small Block Turbo Setup

-
Status
Not open for further replies.

V8-valiant

FABO Gold Member
FABO Gold Member
Joined
Apr 15, 2007
Messages
810
Reaction score
406
Location
Central Oregon
Rating - 100%
8   0   0
Contact seller
Selling this custom made turbo kit, it was made to fit in a early a body with a factory k frame and torsion bars, the early a body is the smallest engine compartment there is so theoretically should fit any Mopar car or truck.

This was made up of a modified headmen block hugger header for the passenger side and a pacesetter header for the drivers side (passenger header flipped to face forward) both headers are mild steel, everything else is stainless steel with v band clamps wrapped in DEI header wrap.

The crossover is 2 1/4 then merged to a single 3” into the 76mm VS Racjng Billet 7875 .96AR T4 Turbo. It has a 3” stainless down pipe that terminates at the passenger floor board and is notched to clear the torsion bar. It’s set up to run a Precision 46mm wastegate and a Tial 50mm BOV.

With everything pictured I’ve got over $3700 in parts, labor and materials. I’m looking to get approximately half the cost back out of it. Asking $1850 would entertain shipping if arranged by the buyer. Reason for selling is to upgrade to an 80mm T6.

5CAB71CA-5CD6-44EB-9C48-C459B0AF9E3D.jpeg


75A03EB3-6C5C-4B8F-AB52-CDD1A8EB7C39.jpeg


75F13401-1B69-4CAA-9799-9C9035E835CA.jpeg


853CB711-9120-43C0-8731-6CF28DFD28A6.jpeg


B9BC0ACE-EFA9-4486-9496-CEB650A8A1B7.jpeg


39086F23-2834-41C5-B282-2EDF8F15FD8C.jpeg


92AB378E-6AD2-49EF-A2EC-7587BB4A07E9.jpeg


27F1E8B9-8BC3-47D0-B33B-320A6DAB0EF3.jpeg
 
Last edited:
I see the electric water pump, is there an alternator set up too?
 
Status
Not open for further replies.
-
Back
Top