[SOLD] Early A body V8 engine mounts

[Moparbrad]

These are from a 65 273 Barracuda. Good condition other than some grease build up.

$75 shipped in the US

 

[Blackhatguy]

These won't fit a 360 will they?

 

[xLURKxDOGx]

These won't fit a 360 will they?

They will but you’ll need washers on drivers side. Perfect for 360 into early a.

Jake

 

[Blackhatguy]

I could use them. Got a 5.9 going in a 64 dart where a slant was. Work for that you figure?

 

[xLURKxDOGx]

I could use them. Got a 5.9 going in a 64 dart where a slant was. Work for that you figure?

I’m sure mr. mopar will chime in at some point and set the record straight.

Jake

 

[Moparbrad]

Guess I’m Mr. Mopar. Yes, they will work on a 5.9 360. You will need to make a spacer on the driver side between the mount and block boss. 340 and 360 have a little narrower mounting boss spread. Way cheaper than buying an aftermarket mount set.

 

[Blackhatguy]

Awesome, pm sent

 

[pishta]

These "bricks" lift the motor off the K more so than the "ice cream sandwich" style.

 

[Blackhatguy]

These "bricks" lift the motor off the K more so than the "ice cream sandwich" style.

I see now, those are quite a bit thicker than the other ones. If nothing else, it should give me a little more room for the headers, yes?

 

[Moparbrad]

These were on a 1965 Barracuda with a 273 and headers.