[Found!] Factory Stock Length Drive Shaft for a 1971 Dodge Demon

-
Status
Not open for further replies.

BerryMoparBloodline

Well-Known Member
Joined
Mar 8, 2013
Messages
108
Reaction score
68
Location
New Market, AL
Rating - 100%
5   0   0
Contact seller
I am looking for a factory stock length drive shaft for a 1971 Dodge Demon with factory yoke on each end. I have a 727 Trans, 8 3/4 rear, and 489 Housing with 3:55 gears.

Thanks In Advance,
Jacoby S. Berry
 
I have an honest question, don't mean to hijack the thread. Is the driveshaft for a 4 speed the same length?
(Looking for 1)
 
Find a driveshaft that is longer with the correct yoke and u-joints ad have it cut to size and balanced.
 
I have the original driveshaft out of my '69 Barracuda 340 auto 8 3/4 rear. '69 Barracuda is108 inch wheel base same as Duster Demon Dart Sport. It has 7290 ujoints because that is how it came from factory. Trans yoke I had replaced years back in good cond. No dents and in overall good condition bolt in ready.
 
I have the original driveshaft out of my '69 Barracuda 340 auto 8 3/4 rear. '69 Barracuda is108 inch wheel base same as Duster Demon Dart Sport. It has 7290 ujoints because that is how it came from factory. Trans yoke I had replaced years back in good cond. No dents and in overall good condition bolt in ready.
PM Sent
 

Here are some pictures of one I have

PXL_20250324_003556111.MP.jpg


PXL_20250324_003540130.jpg
 
Status
Not open for further replies.
-
Back
Top Bottom