65TerrorCuda
Well-Known Member
Going to aluminum heads I needed about .050" shorter pushrods. Easier to make them shorter than longer!
Last edited:
Future 360 cylinder head upgrade parts
- Thread starter n00blike
- Start date
-
MOPAROFFICIAL
If it has tits, it's a liabilititty.
They cut the 45 a mile wide on the Chinese heads.
1st thing I do is a stone drop to clear the chamber and ledge, then open the 45 up, enough to cut a 32 above it..5hen narrow the seat with the 60 pushing it out more on the face and then a 75 below the 60 ... then just blend the short turn and bowls 90 cut.
1st thing I do is a stone drop to clear the chamber and ledge, then open the 45 up, enough to cut a 32 above it..5hen narrow the seat with the 60 pushing it out more on the face and then a 75 below the 60 ... then just blend the short turn and bowls 90 cut.
Last edited:
PRH
Well-Known Member
Recut SM intake seat………
30/45/60/75, mild bowl blend.
30/45/60/75, mild bowl blend.
-
