bc67barracuda
1967 Barracuda - Fastback
Where could I find either the Gas / Temperature sending push on end wire piece. Could I use the condenser wire(pic attached) which is mounted to the back of the instrument cluster? Thanks.
Gas / Temperature sending Wire end piece
- Thread starter bc67barracuda
- Start date
-
The factory original terminals at temp and fuel senders have more rubber boot on them but...
YES any terminal for #10 post would work including the one you suggested. You'll find that particular wire to be steel instead of copper. Doesn't matter. Snip the little barrel portion off something like a ring terminal insert wires to overlap, crimp, heatshrink, done. -> ()_() <-
Factory oil sender connector is where they dropped the ball. That one falls off or gets knocked off, shorts to ground, and kills gauge or limiter or both.
YES any terminal for #10 post would work including the one you suggested. You'll find that particular wire to be steel instead of copper. Doesn't matter. Snip the little barrel portion off something like a ring terminal insert wires to overlap, crimp, heatshrink, done. -> ()_() <-
Factory oil sender connector is where they dropped the ball. That one falls off or gets knocked off, shorts to ground, and kills gauge or limiter or both.
-
Similar threads
