HELP, Will this kit work for a 70 318

[memike]

I have a member asking me are these pistons w/floating pins, I figure he can and will use his that is in the 318 he needs to go .030 over on.
He is rebuilding a 70 model 318 and he said it has bushed rods ops:
I am sure all these 318 have push rods and yes the main and rod bearings are .010 that he said he needs

My question is will my rebuild kit work for him :coffee2:.
I am making sure that his questions are answered correctly :cheers:
And this kit I have for sale will save him a few dolors as I am selling it to him for $100 plus shipping, so to keep my reputation I need your help

here is the thread we need your tec help in
http://www.forabodiesonly.com/mopar/showthread.php?t=154991

Thank you for helping me out on this, we both appreciate the help very much :hello2:

 

[64 SRT8 Dart]

Hey Mike, PM sent.

 

[fishy68]

Mike I can't tell by the pics but if you look at the pistons where the pin goes through right close to the edge it should have a groove on each side for cir-clips if they are for floating pins. If there is no grooves their for pressed pins.