i jsut bought these

[ramman7284]

i just bought a set of 360 heads for my 318 im wanting to know whats a good set up for them. im wanting to open the intake valve to a 2.02 and i want to say a 1.6 exhaust and have each chamber matched in ccs im debating on if i want to put some roller rockers in them but if i do i want to know if i have to go to a roller cam and lifters to. let me know whats a good cc to go to and whats a good piston to use to to get the compression back up

 

[1wild&crazyguy]

open chamber 318 heads are around 68cc's, the 360 heads are a round 72cc's.

I would mill 8cc's off of them to end up at 64cc, but measure the chambers on the 360 head first.

every .0048 milled knocks off 1cc, so just mill them .040 and also mill .040 from the intake side of the heads as well, that or only mill .025 from the intake side and then just use the thinner felpro .035 replacement intake gasket.

jmo