moparmarkk
Well-Known Member
Hi, will the stainless steel tubular header from a 5.9 magnum fit a LA engine? and if so will these pipes work in a 75 A-body with 318-360? thanks , mark
magnum exhaust
- Thread starter moparmarkk
- Start date
-
Magnum exhaust ports are small like 273/318 heads. Some early 340/360 heads have exhaust ports that are larger. You should check if using the early 340/360 heads.
Professor Fate
Push the button, Max...
Well, what chassis were the headers designed for?
If you're talking about the cheapo $200 shorty internet specials advertised for Dakotas and Ram trucks, then no- they do not fit an A body. The passenger side may, but the driver's side tries to take up the same real estate as the steering box and column.
moparmarkk
Well-Known Member
these are the factory dakota pipes, mark
Cuda416
Well-Known Member
Stainless steel factory tubular headers? We're going to need more info and pics .
Professor Fate
Push the button, Max...
Cast iron manifolds from the factory in every Magnum Dak/Ram/van that I've ever seen or heard of. Even the Dak R/T, which it would have to have been, since you say it was a 5.9 Dak.
Last edited:
moparmarkk
Well-Known Member
here you go , dak 5.9 r/t
I would almost bet money they wont .
Look at the rear dump exit,,,,it is way back behind the rear port tube .
I think you will run into firewall clearance there .
Tommy
Look at the rear dump exit,,,,it is way back behind the rear port tube .
I think you will run into firewall clearance there .
Tommy
Cuda416
Well-Known Member
Yes Sir ,,,,,but they don’t fit an A body either .
Tommy
Tommy
Cuda416
Well-Known Member
Just pointing out they're not factory units as the op seemed to imply
lol,,,,yeah ,,,,,I think you’re right .
Tommy
Tommy
moparmarkk
Well-Known Member
was only going by what the seller told me, pricy also ,thanks for the info, mark
Cuda416
Well-Known Member
Just passing on the info.
-
