greyghost340
GreyGhost 340
I am in need of the bushing that holds the brake rod into the master cylinder. Anyone know how I can obtain a new one? Any tips would be appreciated.
Manual Brake Rod Bushing
- Thread starter greyghost340
- Start date
340sFastback
Well-Known Member
greyghost340
GreyGhost 340
Thank you! 
72Duster440
Well-Known Member
Huh, Mine never had one of those, I guess I'll be ordering one as well before I put the master back into the car.
lemondana
BlackDart
Hold on to your shirt when you see how much they charge you for shipping!
72Duster440
Well-Known Member
Has it gone up a lot? I've bought from Cass many times and shipping was always pretty reasonable.
Ironracer
Gearhead
I bought one a few months back it was six or seven bucks free shipping...
If you order through his eBay store shipping is free.
Mopar Manual Brake Push-Rod Retainer, Bushing, Clip, Rubber Grommet | eBay
Mopar Manual Brake Push-Rod Retainer, Bushing, Clip, Rubber Grommet | eBay
It's also 8 bucks there vs 3 bucks direct from his website.
340sFastback
Well-Known Member
I don't have one in my car and its a little worrisome cause the flimsy brake light switch is only thing keeping brake pedal from going too far back and rod falls out then no brakes....I would think a simple O Ring in the rod's groove would do the trick.....
Very true! But at least that way you know the total beforehand. I’m sure it’s about the same either way
62 dodge lancer 340
Active Member
hi bought mine from mancini racing enterprises. in michigan.
Last edited:
lemondana
BlackDart
I think shipping was something like 12.00. I didn't realize he had an Ebay store.
greyghost340
GreyGhost 340
Keeps the rod inside the master cyclinder
