Manual Steering Gear Upgrade

[69 M-CODE CUDA]

Has anyone done their own reconditioning of their steering gear box? It looks like a guy could do this himself, preserving his original case, etc., and also quicken the steering ratio at the same time. That is if this is legitimate;

Firmfeel Mopar Suspension and Steering

Has anyone had any experiences with this approach, supplier, etc.?

Thanks for the help.

 

[Dicer]

I did indeed rebuilt my steering box, painless...I ordered the " FirmFeel" 20:1 and the seal kit used CV joint grease for the box, I am thinking about 6 small tubes, from any supply store. Follow the factory manual for details......My only problem I had was with the selector shaft it did not have a "keyed" spline....FrimFeel lied to me....asked before hand. Had to grind down a spline to make it work.

 

[d1970]

read this it will help you out, it's by Richard ehrenburg

http://www.firmfeel.com/articles/MAarticle2014dec.pdf

 

[69 M-CODE CUDA]

read this it will help you out, it's by Richard ehrenburg

http://www.firmfeel.com/articles/MAarticle2014dec.pdf

Thanks to Dicer and d1970 for some great information. I appreciate it!