Separate names with a comma.
And well we changed are mind so no crusher action:-| So time for the Rotisserie
New Trunk Floor Extension These were AMD metal, nice thickness and fit like a glove
...............Wow Roger, u still have a ways 2 go.........good luck on the build.......kim.....
Min tub started on the passengers side and finished (missing some pics in between and this was done before the new trunk extension was welded on)
Now for the striker posts PO fixed both sides with which I would guess was a stick welder because man they were ugly.
Now to put the 1/4 on.... Test fit Fit nice so it was tacked on
The passenger side door had about an inch thick bondo over what looked like a huge dent made by a boot. So instead of pulling the dent out they just bondo over it:wack: It seems Gary doesn't like his picture taken :icon_smi:
Now for the Driver's side 1/4 Yuk Yikes Mini tub time
Man, I'm thoroughly impressed!! Mega-kudos to you guys jumping in with both feet! Now I want a rotisserie for my Dart!
I'm in, nice car!
Rolling right along! Did you buy your rotisserrie? Man I need one badly..
In a way I did, part of that is going towards the bill plus my blood sweat and tears. My hat off to Gary though I would be lost without his expertise, patience and help. This car had 3 paint jobs in its life green, then red and finally Black so mutiple layers to strip off. rotest: Here the finished welding on the mini tubs, the spare tire was cut out and a aluminium fuel cell will replace the gas tank.
Now here's where the hard work starts the sanding [-o< Still need to take some pics of the drivers side its ready to sand also
Looking good. Nice work so far.
Now on to the front end My many thanks to Stan (stansblue72) who made me a deal I couldn't refuse on mint inner fenders and a rad support for my build. Here's my rusted and cut up for headers front end.......
You Canadian boys dont mess around! That is some serious cuttin and weldin. Kudos for saving her!
Wow those are huge header holes..
this is great!!!
Here's the Driver's side I'm just not digging the look of the gas cap area or a dart gas cap on it :scratch::-k... On to the front end work for now.... No turning back from here :violent1:
stansblue72 donated front end, surface rust only and thanks again Stan. HELLO
I'm really scared to count up the hours we have put in on this project so far.:banghead:
with that 383 use the schumaker headers or tti u don't have to cut the inner fenders half way out with these headers.
Thanks for the suggestion but I have had a set of chassis headers sitting on the shelf here waiting much to long to be put on this thing.
Love what I just saw :burnout: City here you come.