Mopar 400 block 8 sleeves

-
For sure I will post something. I hope it’s going to sound right
Yeah, I have a video on my phone of my engine during break in and it sounds like ****. Good luck with that.
 
Yeah, I have a video on my phone of my engine during break in and it sounds like ****. Good luck with that.
It always sounds better in person but I’ll do my best. If it sound bad I’m not putting it on
 
It’s done but I’m not sure if I can get away with this pushrod length. I think I will give it a shot as is… Normally I like 2 threads showing on adjuster.

FE25967B-014D-429B-8507-A92DB82DB551.jpeg
 
It’s done but I’m not sure if I can get away with this pushrod length. I think I will give it a shot as is… Normally I like 2 threads showing on adjuster.

View attachment 1715963522


As long as the ball on the adjuster is lower than the oil feed hole in the rocker you are fine. You don’t want the adjuster out any farther than it has to be. From the pictures yours look real good.
 
Ok so the pushrods are good, real ratio of HS 1.5 rockers with these is 1.55:1 checked with dial indicator.

There will be no video for now, sound like crap recoding using my phone.
 
-
Back
Top