metallidart
member me?
I have a set of new, in the box, Mopar Performance valvesprings pn P2806077. The description MP gives is 1.83/1.86 installed height, .500/.610 lift, dual w/damper, 1.52 OD. I am pretty sure the installed ht is what B/RB and Hemi engines use. I was going to keep them for my W2 heads, but with my long valves the installed ht is closer to 2.0". I could make it up with shims, locks, etc, but I don't even have a cam picked out yet, so who knows when I will actually need these. With a little planning, like pocket cutting, retainers or locks that move the installed ht higher, I'm pretty sure you could use these on a small block, especially aftermarket heads.
One of the valves is missing the box, and has rust on it. All the others are new and perfect. I was going to buy a new one to replace it, I just don't have the money to yet. These retail for $26 EACH and up...so even though this is a set of 16 that even includes the big box/label, in my opinion only 15 are usable. So, get em cheap! I am asking $100 plus shipping from 44413. Send me a pm!
One of the valves is missing the box, and has rust on it. All the others are new and perfect. I was going to buy a new one to replace it, I just don't have the money to yet. These retail for $26 EACH and up...so even though this is a set of 16 that even includes the big box/label, in my opinion only 15 are usable. So, get em cheap! I am asking $100 plus shipping from 44413. Send me a pm!
