Parts. I D needed. Next round of name that part!

[RAT ROD AL]

I got these with the cuda package awhile back. Thought it was cuda parts. Not to sure about that now. I don't see any #s. Might even be 67 mustang stuff. Rear seat corner finish panels[ ATTACH=full]1715423534[/ATTACH]

View attachment 1715423531

 

[RAT ROD AL]

Might as well ID these while we're at it. Thanks Al

 

[66340SEDAN]

If there’s no part number on it it’s a pretty good indication they are not Mopar....

 

[hemidart67]

2nd pic are K frame to lower rad saddle bracket if I'm not mistaken

 

[Murray]

Correction- 2nd post are two fender braces. Each front fender, top of wheel lip to inner fender top.

 

[hemidart67]

Correction- 2nd post are two fender braces. Each front fender, top of wheel lip to inner fender top.

My bad thanks for the correctiom

 

[RAT ROD AL]

Correction- 2nd post are two fender braces. Each front fender, top of wheel lip to inner fender top.

I was thinking that but they don't seem to fit . I will check again.
Thanks

 

[Murray]

Captive nut end goes to the lip, while the elongated end goes to the inner fender which has the captive nut. Even with the adjustment available, you may have to 'tweek" the bracket. "Tweeking" is a technical engineering term.

 

[cosgig]

I was thinking that but they don't seem to fit . I will check again.
Thanks

those go from the bottom of the front fender skirt up to the splash pan.

 

[RAT ROD AL]

Yep 67 Mustang