[WANTED] PCV Valve with Grommet

[tubbedamx]

Looking for the correct grommet and PCV valve for small block aluminum mopar performance valve covers

PayPal ready
Shipping to 83709

 

[physixx]

I have these that will work perfectly. Use a twist on breather on the opposite VC and drill a hole in the "plugged" section of the cover so that the grommet will seal tightly. I've done this on a few builds and it works great.

 

[Mopar Al]

I have these that will work perfectly. Use a twist on breather on the opposite VC and drill a hole in the "plugged" section of the cover so that the grommet will seal tightly. I've done this on a few builds and it works great.

View attachment 1715877991

do you have that set up that you will sell?

 

[tubbedamx]

I have these that will work perfectly. Use a twist on breather on the opposite VC and drill a hole in the "plugged" section of the cover so that the grommet will seal tightly. I've done this on a few builds and it works great.

View attachment 1715877991

I’ll send you a PM

 

[Bobzilla]

Mancini Racing offers the grommets under part number MOPP5249642, basically the old Mopar number with a few more letters at the front.

 

[Rocket]

I have used these type for PVC. Replaces oil filler twist on cap. No drilling needed.

Trans-Dapt Performance Products 4999 Trans-Dapt Performance Chrome Valve Cover Breathers | Summit Racing

 

[tubbedamx]

Mancini Racing offers the grommets under part number MOPP5249642, basically the old Mopar number with a few more letters at the front.

Thanks for the numbers, I forgot about Mancini