pinion offset

[dartlove]

Hello fellow members, I called alstons in sacramento this morning to order a ladder bar rear subframe. Mike asked about the offset. I measured and come up with about 2 1/2".
I was told that sounded a bit much. My question to you all is does anyone know the correct pinion offset on a 1964 dart gt?

 

[amx364]

I do not know, however your figure of 2 1/2 might be correct. For a stock setup, what rear end are you going to use and where do you want it to end up at? The stock floorboards are offset. The tunnel does forgive quite a bit if you do center it.

 

[Coronet 500]

Actual 1 3/16". Center of pinion to center of differential not housing or axle ends. Housing may have different length tubes and axles to position driveshaft in body.