Qa1 k-member

[Rmoore]

Do you use the torsion bar setup with the qa1 k-member ?? Do the factory upper and lower control arms work ??

 

[TheGrateRonzini]

Yes to all. I bought the QA1 tubular set up though. Cause mine is a 67 and I wanted BBJ. I notice this is in BigBlock forum, I have yet to see if I have to cut anything off where the mounts go to fit the 440. AndyF motor plate and tti 2”

 

[Rmoore]

Yes to all. I bought the QA1 tubular set up though. Cause mine is a 67 and I wanted BBJ. I notice this is in BigBlock forum, I have yet to see if I have to cut anything off where the mounts go to fit the 440. AndyF motor plate and tti 2”

Mine is going to be a 72 Dart 500/ 440 also

 

[TheGrateRonzini]

Sweet! Can’t wait for some pix. The QA1 K is on top of the trash can in first pic. I also used it to square the front rails I replaced. Only the bottom end is assembled for real. Waiting on A-855 and I don’t like to seal up the top end if there is an undetermined time before I fire it up

 

[Rmoore]

Sweet! Can’t wait for some pix. The QA1 K is on top of the trash can in first pic. I also used it to square the front rails I replaced. Only the bottom end is assembled for real. Waiting on A-855 and I don’t like to seal up the top end if there is an undetermined time before I fire it upView attachment 1715306543 View attachment 1715306545

Which heads and intake

 

[TheGrateRonzini]

Trick Flow 240 and whatever their intake is called. Track heat or track max. Harland sharp rockers

 

[5.7 hemi]

QA1 in my 69’ Dart GT with a 470, 4 speed and Dana 60. I run a 6 qt. Hemi pan and no interference problems with the idler or center link. Oh, it’s got ac too!