[SOLD] Slant 6 Exhaust Manifold Cast Iron Elbow

[slant six]

This exhaust elbow was on a Forklift. It has been blasted, painted, and ready for your project.

It could be used with some sort of turbo project, the exhaust tubing is a slip fit over the end. It is cast iron and will bolt to the Bottom of a Stock Slant 6 Exhaust Manifold.

Asking $15 Plus Shipping from 15642, PA to you.

 

[RustyRatRod]

What's the ID on both ends?

 

[slant six]

What's the ID on both ends?

29/64" To fit Stock 7/16 Slant 6 Exhaust Manifold Studs / Bolts.
There may be enough material there to enlarge the holes to 1/2" diameter.

 

[RustyRatRod]

29/64" To fit Stock 7/16 Slant 6 Exhaust Manifold Studs / Bolts.
There may be enough material there to enlarge the holes to 1/2" diameter.

I meant the exhaust opening on each end.

 

[slant six]

I meant the exhaust opening on each end.

Sorry, 1 7/8" For both the flange and tube ends.

 

[RustyRatRod]

Sorry, 1 7/8" For both the flange and tube ends.

No problem. Thanks. I was hoping maybe a little bigger.